@Robbp12 Mine froze today, after running at release 1.20.14 for almost a month without any problem. Now performed a factory reset, and will wait until there is another freeze before changing the...

@Hank21 Actually, I'm not so sure anymore I have same issue as Robbp12. After upgrading to beta firmware 1.20.14, the sx3008-f froze within 48 hours. I powered it off then on and planned to wait...

@Hank21 The issue is already described in posts #1 and #6 of this thread. As for topology, this is a pure layer-2 switch, providing network access to two computers. It's the only switch on the...

@Robbp12 , Thanks for the heads-up. Will definitely try but wait until I get another freeze. Looking at the current config (from the CLI), do not see anything unusual This is a brand new switch I...

Hi @Hank21, I also have same issue with my sx3008f. If you need additionnal info, please PM me. I use the switch in standalone mode (no controller) . Could not even acces the CLI through the console...