You could remotely manage the opposite CPE, too.

baldog wrote Is there a way to test the link between the cpe's? Yes, see Tools->Speed Test. Start a ST server on one CPE and a ST client on the other. This will show you the data speed on the...

baldog wrote By looking at the figures on the right hand side of the status page of the cpe towards the bottom. No reliable source for measurements. WiFi gear always negotiate speeds dynamically and...

The device name is just EAP220 followed by its MAC address. It is always different for each single device. If both use firmware v2.x, they are both hardware version 2. As for the ESSID: same ESSIDs...

How do you measure this? Using built-in speed test or by looking at the graphs on the Status page? If rate goes down, for how long and is this during transmission of data or in idle phases?

jhill wrote is the EAP110 outdoor run the same firmware and captive portal admin software as the indoor 110 unit???i dont see ANYTHING on this site for support for this product??? Yes, same software....