Forums/
Controllers
15 hours ago
@Vincent-TP Hi - I tried switching that off and the nag is still there along with these damn warning triangles. It would be appreciated if this can be switched off as it appears when the page is...
0HELPFULS
Forums/
Controllers
Monday
@Vincent-TP Thanks for the reply - I will go test this - I had assumed that this would stop it checking for an update as OPOSED to flagging/nagging that the device firmware was unsupported. Thanks
0HELPFULS
Forums/
Controllers
a week ago
@Vincent-TP I have a couple of switches that clearly need firmware updates but still work. Is there any way to turn the nag off in the gui to go get an update (which is not likely to be available)?...
0HELPFULS
Forums/
General Discussion
2025-08-15 07:11:16
Hi - and thanks for the reply. We already use Omada for APs and know our way around. So, a specific question then... We have a good number of T2600G-52TS V2.0 , which also state TL-SG 3452 V3.0 Is...
0HELPFULS
Forums/
General Discussion
2025-08-14 19:10:57
Guys I am struggling to find clear guidance as to the support postion for TP-Link devices by the current Omada management options. I have found a site that attempts to provide guidance, but as there...
0HELPFULS
Forums/
Gateways
2024-06-08 10:09:52
Hi Guys I have just migrated to Omada and five wifi6 access points - and like the platform. Use case is home... with just over 100 wifi devices and about 90 wired devices, and 1GB FTTP. Before I buy...
1HELPFULS