@Kevin_Z Thanks for your reply, but that doesn't clear things up. The problem is the FW thinks the HW is v1, but the serial sticker on the back says it's v2.1. Which is it? Can I flash v2 FW to this...

Ok. So I just had my main node crash and refuse to come back up and was forced to hard reset it and re-setup my whole network. I'm supremely annoyed to find out that there's no config backup...

@MarkHNZ Oh just wait until the main node crashes and never comes back up and you have to hard reset it and re-setup not just your settings but every node, too. Nuts! I'm just gobsmacked that they...

@Andone This is a 10+ year old pre-GB ethernet device. I have no idea what it supports. All I know is that new devices "should" be backwards compatible. If they're not, well, that was a design choice...

So, last week I setup a Deco M5 mesh network in my home. Works great. However, the base deco only has two ethernet ports - one for incoming internet from my modem and one for other devices - of which...

@Mitya Any thoughts WRT my Linksys PAP2? I have no PoE requirements.