That was a frustrating experience, but I seem to have restored things. Here is how I did it after resetting the ER605 multiple times. Reconfigure the LAN interface to use address 192.168.3.1 and set...

So, trying to recover from the router disconnected from the Omada controller I reset the router, and now I am encountering even more problems. My controller is on a management network that I set up...

Since this relies on EAP firmware, does it require ALL EAPs to support it? I assume so. It would be useful to know which EAP models will get the feature and which will not.

My understanding is that the Smart DHCP is intended to kick in if the powerline device detects that there is no DHCP server on the network. I guess this was done to allow clients to access the config...

It's very disappointing that the TP-Link folk responding to a message to this thread, over 200 messages long, don't consider that context and treat new messages as if they were brand new support...

I was subsequently informed by TP-Link support that the ER605 also uses 192.168.0.1 as a default address. It appears that I was reaching this instead of the switch address due to the conflict and...