@SlySly "Keep in mind that this setting is per wireless SSID, not a global setting. "Sly reply" please elaborate" That means setting the "phone MAC" is done per current SSID that the mobile is...

@CI23 Putting VR2600 in bridge mode is straightforward procedure: Just observe its original settings like DSL modulation type and any specific VLAN ID (if provided by your ISP). On AX73 a connection...

@bwsteel HX510 support both router mode and access point mode - check its datasheet here. To switch between modes there should be an Operation mode menu - usually in Advanced settings: Launch a web...

@FJ2000 If it's not a cabling issue then probably the issue is with R480t+ configuration. Archer C60 should run in AP mode just out of the box.

@FJ2000 Here's a guide for setting up Archer C60 in AP mode (Case 1). Connect R480t+ LAN port to Archer C60 WAN port. Archer C60 LAN IP address could be set as Smart IP (DHCP) or Static IP - depends...

@SlySly You have a similar issue with the Sly-Galaxy-S10e - probably you're using a randomized MAC address instead of the phone MAC address for the wireless SSID that the mobile connects to - the...