Following is my setup 1. TL-ER5120 v4.0 (load balancer/modem) 2. POE SWITCH TL-SG1210P 3. EAP225 (8no) I have 2 fibernet connections of same isp. Max users connected at a same time are 25. My android

Hello, after flashing back from openwrt to original firmware the cpe510 became bricked. i have tryied to recover the original firmware through Tftpd32 but as i can see the Cpe510 asks for recovery.b

Hi, Not sure if someone can help me? I currently use a EAP115 in the upstairs of my house running off a cable from my Virgin Router. The signal strength isn't overly good even in a small small 3 bedro

I was trying to configurate ER605 but I have question? Could I allow severals ips Firewall by Acces Control and several websites by URL Filtering? If I allow severals ips Firewall by Acces Control the

CPE's all configured in 192.168.2.xxx Network & IP cameras all configured in 192.168.1.xxx network, however both gadgets are carrying same SNM. In this scenario, is network topology will be successful

I am setting up my EAP245v3 and am running into a strange problem. If I leave the channel selection on auto, it is placed on a frequency where there is already an AP. I have 3 APs so I want to use cha