I have 3 CPE710 set as Client and 1 CPE710 setup as AP All 3 Clients are spread out within about 60 to 75 degrees from the AP 1 Client is about 5 to 7 miles aways from AP and sees the AP but cannot co

TP Mesh Link controlled by Omada seems very slow and causing bandwidth issues and IP cameras to breakup and stop recording for 6 to 10s intervals, seemingly randomly. Data Path is …. 2*IPC’s (cameras)

I have setup two CPE 510s, I have one steup as an access point and the other setup as a client. I am sure they are communicating with each other from the status pages of each device. I am wanting to c

Good Day, I have a issue, I can't adopt EAP Devices after I reach 20 on my online Omada Software Controller (Linux). Is there a EAP Limit per Site? if yes how to remove the EAP Devices Limit per Site?

Which ports and target IP addresses must be enabled so that the software controller can connect to the cloud access?

So we use two of the CPE510s as a wireless point to point bridge from our fourth floor office near the window to the top of a parking garage about 130 meters away (which is not far at all for these th