RickJamesBishLV4Online
Following: 0Followers: 6
Forums/ Pharos Wireless Bridges
By Kaizoku 2023-07-16 06:47:59

CPE & EAP connectivity

I am planning to extend my router range in an industrial area. Currently there is another factory in between my two factories similar to the below picture (the middle space replaced by another house).
Forums/ Pharos Wireless Bridges
By DirtySanchez 2023-07-19 01:12:35

Possible or not??? CPE510 in AP Mode (from exstisting Wifi) + Client Mode (wired)

Hello, Is this possible to set up with 2 CPE510 APs? The plan is to receive an existing WiFi signal from the router1 (white) with the 1st CPE510, bridge it 30m to the 2nd CPE510 (client) and plug that
Forums/ Pharos Wireless Bridges
By HenrikBage 2023-07-17 18:09:36

CPE210 bridge no internet...

I just set up a bridge with 2x CPE 210. I did the quick set-up, attatching the access point to each other. I get good signal strength. They are approx 60 m (200ft) apart. However, I cannot get interne
Forums/ WiFi
By rakrouki 2023-07-18 09:55:43

EAP 225 v3 lan connection not passing gigabit

My EAPs are connected via cat6. when i check in settings, i see that the connection is 100 not 1000, i wonder why.
Forums/ WiFi
By RickJamesBish 2023-07-18 11:28:12

Hats off to TP-Link and OMADA

I built a WiFi network for the RV Park we are staying in long term. This consists of an EAP610 OD wired to a TL-SG2210MP with an OC200 Controller. The switch in turn in wired to a Unifi UDM Pro Gatewa
Forums/ WiFi
By Fozzie Bear 2023-07-17 14:47:56

Problems with Omada Software and Static IP

Following advice received on my previous forum post here I have sucessfully installed 2 x EAP245 and one EAP225-Outdoor in our community hall. All devices powered up fine. Unfortunately I am unable to
1567...