Is there a way to force a device to connect to the network via wireless mesh vs. ethernet? Here's the situation: Internet ---> Root AP ))))) wireless mesh link ))))) Remote AP ---> ethernet switch ---

I have a bunch of outdoor and indor EAP's and from time to time I get random messages that an EAP was isolated/disconnected from the controller (OC200), and then minutes later it's re-connected. Some

I have a few CPE210's that I use for bridges, and I thought I'd check out Pharos Control software. After realizing it doesn't do anything of value for my specific installation I decided to uninstall i

I've created a mesh between a wired EAP610-Outdoor, and a remote EAP610-Outdoor. Signal strength is ~62dbi, Tx Rate: 432Mbps+, Rx Rate: 288Mbps+. When I do a speedtest to a local OpenSpeedtest server

Latest Firmware Release > Early Access < Omada_SDN_Controller_v5.15.6.4 Windows (Windows 7/8/10/11/Server, 64bit Recommended) Omada_SDN_Controller_v5.15.6.4_linux_x64.tar Omada_SDN_Controller_v5.15.6.

I have 2 EAP610-Outdoor's and and an EAP225- Outdoor.... One EAP610 is close to my other one, but not wired to the 610, and the EAP225 is wired to the EAP610.... so this: EAP610 (((- wireless EAP610--