RE6000XD sendet zwei getrennte W-Lan Netze 2,4Ghz und 5Ghz getrennt, anstatt nur ein Netz wie bei den meisten Repeatern heute üblich, was kann man machen, damit beide zusammen gesendet werden?

I have an Archer NX200 and two RE650 V2 units distributed around my house. It’s a real shame that I still have to connect them using the standard method instead of Mesh, since the RE650 V2 doesn’t sup

Hello! I've been trying to troubleshoot my RE220 WiFi speeds, so I set it up as AP to diagnose. I've switched the RE22' over to AP mode and attached it directly to the router with an Ethernet cable. I

Ac1200 power led and the middle signal force blink blue My PoE light is full and steady until i plug the ethernet cable to the device and then start fading and blinking green at the same rate of the a

My quesiton is about the RE653BE. Does it have a two or three pronged plug please? I cannot find any photos of the back of the unit online, not even a VR 360° view. Where I live this really matters. M

Hello, there is a bug in the firmware update number 240929 of my VR600 v3 modem. After enabling IPv6 and saving, when I try to disable IPv6 again, when I press save, the modem freezes. No functions ca