I am trying to use OpenAPI for the first time and run into a block -- I have created an openAPI client-mode application. First question: after creating it is there something I have to do to activate i

I have VPN between two sites (each with an ER605 router managed by an OM200) connected using IP-sec. Site B does not have any pubically accessible IP address (the ISP NAT's everything so there is no w

Any trick to getting an EAP225 outdoor to connect to a hardware controller? I am ust getting ogoing but two regular ceiling/wall mount EAP'245's simply showed up on the OM200 device list ready to be a

Off to a rather inglorious start to what I thought would be a simple upgrade from an earlier TP-Link router. I did not want to simply replace the old router anbd start configuring with the ER605 plus

I have three sites, each with a small network. The three are then interconnected using IPSec VPN tunnels. The primary site is my house. The other two sites are a second house (hundreds of miles away)