LB 130 set brighness to between 0 and 1 percent
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
LB 130 set brighness to between 0 and 1 percent
Model : LB130
Hardware Version :
Firmware Version : 1.6.0 Build 170703 Rel.141938
ISP :
Hi
I have a LB130(EU) bulb. I would like to set the brightness to be less than 1% (but still on).
I am using some code to set the bulb brightness to 1%. If I use a large enough value for a transition period, then I can see the bulb move through a number of stages of brightness before reaching 1% (so the bulb is capable of a brightness of < 1%).
Is there a way to set the brightness to 0.5% (as an example)?
Thanks and regards,
Pete
Hardware Version :
Firmware Version : 1.6.0 Build 170703 Rel.141938
ISP :
Hi
I have a LB130(EU) bulb. I would like to set the brightness to be less than 1% (but still on).
I am using some code to set the bulb brightness to 1%. If I use a large enough value for a transition period, then I can see the bulb move through a number of stages of brightness before reaching 1% (so the bulb is capable of a brightness of < 1%).
Is there a way to set the brightness to 0.5% (as an example)?
Thanks and regards,
Pete