NC450. Power surge during firmware update.Maybe there is a chance?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC450. Power surge during firmware update.Maybe there is a chance?
Model :
Hardware Version :
Firmware Version :
ISP :
Hello.
There was some power surge during firmware update. After that camera only shows fast blinking green LED. when connected to router - no info in DHCP table.
Maybe there is a way to resurrect the device? Bios dump? (some friend of mine had minipro tl866 programmer) Some sdcard bootable firmware image? Unfortunately, authorized service is not an option.
any tips/solutions will be greatly appreciated. it'll be a pity to brick such a nice device by such a minor accident.
Thanx in advance.
Hardware Version :
Firmware Version :
ISP :
Model : NC450
Hardware Version : V2
Firmware Version : NC450(UN)_v1.1.6_161124
Firmware Version : NC450(UN)_v1.1.6_161124
Hello.
There was some power surge during firmware update. After that camera only shows fast blinking green LED. when connected to router - no info in DHCP table.
Maybe there is a way to resurrect the device? Bios dump? (some friend of mine had minipro tl866 programmer) Some sdcard bootable firmware image? Unfortunately, authorized service is not an option.
any tips/solutions will be greatly appreciated. it'll be a pity to brick such a nice device by such a minor accident.
Thanx in advance.
