Tp Link NC200 brick after update the firmware
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tp Link NC200 brick after update the firmware
Model :
Hardware Version :
Firmware Version :
ISP :
I configure the camera on an Android phone, and i update the firmware on a computer. The internet was interrupted during this process because of the internet service, and after that the camera don't respond and the red led is flicking.
Any solution? Can I upload the firmware again with any other method?
Hardware Version :
Firmware Version :
ISP :
I configure the camera on an Android phone, and i update the firmware on a computer. The internet was interrupted during this process because of the internet service, and after that the camera don't respond and the red led is flicking.
Any solution? Can I upload the firmware again with any other method?
