Tp Link NC200 brick after update the firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tp Link NC200 brick after update the firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tp Link NC200 brick after update the firmware
Tp Link NC200 brick after update the firmware
2018-04-16 22:51:13
Model :

Hardware Version :

Firmware Version :

ISP :

I configure the camera on an Android phone, and i update the firmware on a computer. The internet was interrupted during this process because of the internet service, and after that the camera don't respond and the red led is flicking.


Any solution? Can I upload the firmware again with any other method?
  0      
  0      
#1
Options
1 Reply
Re:Tp Link NC200 brick after update the firmware
2018-04-18 08:34:41
How about hard reset the cam?
Can you still login to the web UI of cam?
If yes, try to check whether it's updated successfully.
If you even can't login to it, it may damage the device because of internet disconnection during updating.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 590

Replies: 1