Smart Home Community > Tapo Smart Cameras > Nc220 continuous red light flashing
< Tapo Smart Cameras

Nc220 continuous red light flashing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Nc220 continuous red light flashing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Nc220 continuous red light flashing
Nc220 continuous red light flashing
2018-05-27 17:51:26
Model :

Hardware Version :

Firmware Version :

ISP :

Pls help...i cannot reset my nc220 camera..the red light continuously flashing..pressing the wps button for 5 seconds doesn't work..
  0      
 
  0      
 
#1
Options
1 Reply
Re:Nc220 continuous red light flashing
2018-05-28 19:51:07
Used as the RESET button: With the camera powered on, press and hold the WPS/RESET button for more than 5seconds until the System LED turns off. Then release the button and wait the camera to reset to its factory default settings. You may refer to above method to reset it again.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1080

Replies: 1

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.