App TP-LINK Camera Close

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

App TP-LINK Camera Close

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
App TP-LINK Camera Close
App TP-LINK Camera Close
2020-07-03 16:14:54 - last edited 2020-07-12 15:47:14

Hi. I have a problem with the TP-Link Camera application. When I turn on the computer, it loads the application automatically and starts recording. There is a lot of space on the hard drive.
After two or two and a half hours, the application closes on its own.
I have connected by wifi a TP-LINK NC450 2.0 camera with Firmware 1.5.3 Build 200304 Rel.7B8C9B.
I need to fix the problem.
Thank you

 

Hola. Tengo un problema con la aplicacion TP-Link Camera. Cuando enciendo la computadora, carga la aplicacion automaticamente y cominza a grabar. Hay mucho espacio en el disco rigido.
Luego de dos o dos horas y media, la aplicacion se cierra sola. 
Tengo conectada por wifi una camara TP-LINK NC450 2.0 con Firmware 1.5.3 Build 200304 Rel.7B8C9B.
Necesito solucionar el problema.
Gracias

  0      
  0      
#1
Options
4 Reply
Re:App TP-LINK Camera Close
2020-07-15 07:14:01

@Sergio07 

 

Hello,

 

Do you mean the Camera Control Utility for the NC450 will auto-run whenever you turn on your computer? If so, you can disable the auto login on the utility settings page to give it a go.

 

Thanks.

  0  
  0  
#2
Options
Re:App TP-LINK Camera Close
2020-07-15 22:32:27

@Sergio07 

 

Lo intentaré a ver si es eso que hace que se cierre solo.

Gracias

  0  
  0  
#3
Options
Re:App TP-LINK Camera Close
2020-09-10 23:24:19

@ Sergio07 

Necesito que se inicie automaticamente TpLink camera cuando inicio la computadora. Si elimino el inicio automático debo ejecutar yo el programa y eso no me sirve.

Necesito que sea automatico,.

 

  0  
  0  
#4
Options
Re:App TP-LINK Camera Close
2020-09-15 11:23:02

@Sergio07 

Good day.

Sorry for the delay.

Have you tried to download the new version of the controller utility for NC450:

Camera_Control1.0.5.1

https://static.tp-link.com/2019/201903/20190328/v1.0.5.1.zip

Have you checked whether it is caused by the Hibernation and Hybrid Sleep of windows 10?

Did it happen all the time or randomly?

Thank you very much.

  0  
  0  
#5
Options