Forums

Stories

Knowledge Base

Smart Home Community > Tapo Smart Cameras > nc450 tls configuration

< Tapo Smart Cameras

nc450 tls configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

nc450 tls configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

BobL

LV1

2020-10-14 00:32:41 - last edited 2020-10-20 07:19:59

Posts: 2

Helpful: 3

Solutions: 0

Stories: 0

Registered: 2020-10-14

nc450 tls configuration

2020-10-14 00:32:41 - last edited 2020-10-20 07:19:59

Model: NC450

Hardware Version: V2

Firmware Version: 1.5.4 build 200401 rel.A4EEDD

Unable to load the web interface in Microsoft Edge and Chrome as it is displaying this message apparently because this is turned off. Question: is there a way around this in the settings of the camera.

"The connection used to load this site is TLS 1.0 or TLS 1.1, which are outdated and will be turned off in the future. When these are turned off, you won't be able to load the site. The server should use TLS 1.2 or later."

1 Accepted Solution

Brook

2020-10-16 02:31:39 - last edited 2020-10-20 07:19:59

Posts: 466

Helpful: 212

Solutions: 133

Stories: 0

Registered: 2018-12-14

Re:nc450 tls configuration-Solution

2020-10-16 02:31:39 - last edited 2020-10-20 07:19:59

@BobL

Good day,

Thank you very much for your kind feedback.

Please refer to the following suggestions:

Type chrome://flags/ on the address bar;
Then search for TLS, set "Enforce deprecation of legacy TLS versions" to "Disabled" This will avoid the popup notice;

Such as the following links:

https://support.google.com/chrome/thread/60199452?hl=en

https://support.google.com/chrome/thread/60353630?hl=en

Thanks a lot.

Recommended Solution

2 Reply

Brook

2020-10-16 02:31:39 - last edited 2020-10-20 07:19:59

Posts: 466

Helpful: 212

Solutions: 133

Stories: 0

Registered: 2018-12-14

Re:nc450 tls configuration-Solution

2020-10-16 02:31:39 - last edited 2020-10-20 07:19:59

@BobL

Good day,

Thank you very much for your kind feedback.

Please refer to the following suggestions:

Type chrome://flags/ on the address bar;
Then search for TLS, set "Enforce deprecation of legacy TLS versions" to "Disabled" This will avoid the popup notice;

Such as the following links:

https://support.google.com/chrome/thread/60199452?hl=en

https://support.google.com/chrome/thread/60353630?hl=en

Thanks a lot.

Information

Helpful: 3

Replies: 2

nc450 tls configuration

nc450 tls configuration

Information

Voters 2

Tags