ER605 WAN default gateway issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 WAN default gateway issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 WAN default gateway issue
ER605 WAN default gateway issue
2023-08-10 10:27:42
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.3.0 Build 20230511 Rel.51317

Hi

 

I set up a single WAN Dynamic IP configuration. All params (IP Address/Subnet Mask/DNS) populated correctly except Default Gateway.

Default Gateway set to 0.0.0.0.

 

System Log:

DHCP Client    NOTICE    WAN: DHCP client getting IP succeeded. (IP-Address=***.**.***.**, Mask=255.255.255.0, Gateway=0.0.0.0)

 

The old router works well.

 

Is it a firmware\ISP issue?

 

Thanks!

  0      
  0      
#1
Options
5 Reply
Re:ER605 WAN default gateway issue
2023-08-10 10:49:20 - last edited 2023-08-10 10:50:40

  @Flysky I had exactly same problem (ISP Vodafone Czechia, exUPC network, modem Vodafone Station TG 3442). Putting a switch between the modem and router resolved the issue. 

  0  
  0  
#2
Options
Re:ER605 WAN default gateway issue
2023-08-10 11:31:59

  @phongtom Yes, switch in a middle helps but I was planning to simplify and reduce the number of devices smiley

  0  
  0  
#3
Options
Re:ER605 WAN default gateway issue
2023-08-11 03:06:32

  @Flysky 

any luck with mac clone?

ScReW yOu gUyS. I aM GOinG hoMe. —————————————————————— For heaven's sake, can you write and describe your issue based on plain fact, common logic and a methodologic approach? Appreciate it.
  0  
  0  
#4
Options
Re:ER605 WAN default gateway issue
2023-08-11 05:50:19

  @Flysky I think no, I tried MAC clone too, enable Get IP using unicast DHCP, changing Negotiation mode from Auto to 1000M full duplex but they didn't help 

  0  
  0  
#5
Options
Re:ER605 WAN default gateway issue
2023-08-11 06:41:50

Hi @phongtom 

In WAN config, does it show up there? Or this issue only exists in the remote log system?

Is there any connection problem?

  0  
  0  
#6
Options