Negotiation Speed

Negotiation Speed

Negotiation Speed
Negotiation Speed
3 weeks ago - last edited 3 weeks ago
Model: Archer VR2800  
Hardware Version: V1
Firmware Version: 0.9.0 0.9.1 v006c.0 Build 221025 Rel.61007n

Hello Team,

 

I just hooked up my TAPO C520WS security camera to my modem using a Cat6a Ethernet cable (LAN 1) and the Negotiation Speed is only showing 100, whereas both my PC's are showing 1000 (LAN 2 & LAN 3). The PC's are connected with Cat8 Ethernet cables, so I'm just wondering if that is the reason?

Any assistance in helping me understand this would be greatly appreciated. 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Negotiation Speed-Solution
3 weeks ago - last edited 3 weeks ago

  @Joker_1660 

 

That's pretty nomal - TAPO C520WS has 1× 10/100 Mbps RJ45 Port.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options
2 Reply
Re:Negotiation Speed-Solution
3 weeks ago - last edited 3 weeks ago

  @Joker_1660 

 

That's pretty nomal - TAPO C520WS has 1× 10/100 Mbps RJ45 Port.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options
Re:Negotiation Speed
3 weeks ago

  @terziyski Thank you. I didn't even think of looking at the camera interface.

  0  
  0  
#3
Options