Automation Camera/lights
Hello!
I've created an automation that when the camera detects a person entering the home after sun set, the lights should turn on!
The problem is that they turn on 1 by 1, instead of all together! I've tried the automation by adding the group of lights and also by adding the 1 on 1!
Any thoughts?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
What's the signal strength of the smart bulbs (Tapo app > device control page > Device Settings > Device Info, tap the WiFi or signal icon to show the RSSI rate)?
Automation commands are mainly issued through the cloud server, so there may be a delay in execution between different devices.
- Copy Link
- Report Inappropriate Content
@Wayne-TP
The signal is at:
-47 (RSSI)
-44 (RSSI)
-42 (RSSI)
-41 (RSSI)
3 full bars (max) on the Wifi logo, before clicking on it to see the RSSI.
I don't use any hub! Would it help?
I've also noticed that the first time (each day) when I do a shortcut it has a little bit of delay. For example I have a shortcut to activate all lights (right now, just 4), and the first time I use it each day, it seems to take extra time or turns on just 2 or 3, and after a while, activates the last one.
- Copy Link
- Report Inappropriate Content
How many L630 you have in one automation? Do they always turn on one by one? What is the time interval? Like 1s?
Or do they turn on in random combinations? Any pattern? For example, two bulbs turn on together and then another one lighting up after 1 second, 2s later another three turn on, etc.
- Copy Link
- Report Inappropriate Content
@Wayne-TP
"How many L630 you have in one automation?"
Only 4 lights!
"Do they always turn on one by one? What is the time interval? Like 1s?
Or do they turn on in random combinations? Any pattern? For example, two bulbs turn on together and then another one lighting up after 1 second, 2s later another three turn on, etc."
As i mentioned in the previous message, it's seems to happen only in the first time each day that I do a "Shortcut" or an "Automation". Regarding the delay/cadency, it seems random. Sometimes they light up 1 by 1 with 2 or 3 seconds in between, sometimes 2 at the same time and the last 2 individually. I haven't figured out a pattern yet.
For example, I have a "Shortcut" to activate all 4 lights. Yesterday, the 1st time i used it that day, they went on 2x1x1, with a 1 second or 2 in between. I then proceed to shut off all for lights (whitin the group), they all shut off at the same time. Next I ran the shortcut to activacte all lighs again, and all lights turned on at the same time.
- Copy Link
- Report Inappropriate Content
Please try pinging the light bulb with your phone from different locations in your home, such as the area where the camera is located, and observe the delay. You use the network tools app like Network Analyzer. Tapo light bulb's IP address can be found on the Tapo app: smart bulb device page > Device Settings > Device Info. Or you can check it from router's client list.
Network device delays and packet loss exist in every network. For a cloud feature, response delays are inevitable.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 83
Replies: 5
Voters 0
No one has voted for it yet.