T100 motion sensor deactivation delay
I've installed the T100 on the frame of the main entrance door and set it up with a shortcut so that before enetering home again it stopped sending notifications to the h200 hub. But, it actually stops sending notification only after 2-3 minutes from deactivation, that is if I enter home immediately it sends an alarm to the h200. Is there a way to eliminate this delay?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Do you use shortcut to disable T100 automation manually in the Tapo app? Or is it done through geofencing automation?
What type of notification are you referring to? Device's notification of the T100 sensor? Or the customized notification in the smart action?
- Copy Link
- Report Inappropriate Content
You: Do you use shortcut to disable T100 automation manually in the Tapo app? Or is it done through geofencing automation?
Me: Through a shorcut.
You: What type of notification are you referring to? Device's notification of the T100 sensor? Or the customized notification in the smart action?
Me: It's the T100 sensor notification that I receive on my smartphone.
- Copy Link
- Report Inappropriate Content
Add a different type of operation or device control operation in the shortcut, check if there are similar delays.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 101
Replies: 3
Voters 0
No one has voted for it yet.