advice needed on how to get the system working properly
I have the following
Battery Video Doorbell, 2K 3MP, Colour-Night Vision, Chime Included, Tapo TD21
Smart Hub with Chime, Work with Smart Switch, Button and Sensor, Connect Up to 64 Devices, Tapo H100
Smart Contact Sensor, Window/Door Safeguard, Tapo T110 Triple Pack
Smart Motion Sensor, Tapo T100 Triple Pack
when i first installed i could get the moption sensors in my kitchen and living room to trigger an alarm if there was motion
now my video doorbell work and the contact sensors on the front door work but the motion sensors wont trigger the alarm if a set it and then test it by walking in front of them
how do i get some support to get this working
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Make sure you've created automation rules for these devices. How to create Smart Action (Automation or Shortcut) on Tapo app
If the rules are not functioning or if there are any operational issues, please check for potential conflicts in the settings and ensure that everything is configured correctly (such as verifying the effective time and confirming that the correct devices are selected).
- Copy Link
- Report Inappropriate Content
Make sure you've created automation rules for these devices. How to create Smart Action (Automation or Shortcut) on Tapo app
If the rules are not functioning or if there are any operational issues, please check for potential conflicts in the settings and ensure that everything is configured correctly (such as verifying the effective time and confirming that the correct devices are selected).
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Why did you put these three sensors in the IF section again? Do you want the hub to ring only if all three sensors are in the right state at the same time?
- Copy Link
- Report Inappropriate Content
thanks
i was trying to set them up with the intention to create an alarm in the house
so when the front door, the garage door and the kitchen motion sensor are closed and have been told be in alarm on mode then if they open or there is movement the alarm rings and i get a phone notification
- Copy Link
- Report Inappropriate Content
So, do you intend for the hub to ring only when all three sensors are simultaneously open and detect motion? That is what your current configuration implies.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 449
Replies: 8
Voters 0
No one has voted for it yet.