Bell not powering on after battery recharge

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bell not powering on after battery recharge

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AaL2024

2025-08-05 00:42:08 - last edited 2025-08-15 08:51:56

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2025-08-05

Bell not powering on after battery recharge

2025-08-05 00:42:08 - last edited 2025-08-15 08:51:56

Model: Tapo D230S1

Hardware Version: V1

Firmware Version: 1.2.0

Hello,
My D230 is not powering on after a battery recharge. The battery has been fully charged, and when I insert it back into the bell, it's not powering on at all. Since it's not powering on, I am unable to reset either. I have done this successfully before and am not doing anything incorrectly I believe.

Can you pls advise on what I can do?

1 Accepted Solution

Wayne-TP

2025-08-05 12:05:56 - last edited 2025-08-15 08:51:56

Posts: 8798

Helpful: 1380

Solutions: 3192

Stories: 13

Registered: 2020-06-23

Re:Bell not powering on after battery recharge-Solution

2025-08-05 12:05:56 - last edited 2025-08-15 08:51:56

@AaL2024

Does the battery's LED indicator lit up normally, solid green or amber? Check whether the battery was charged with a 5V USB charger.

Try to change a battery if you have a spare one. There aren't many things that can be done in regard to this situation, as the doorbell shows no response to reset, and if it is charged correctly, then it is time to seek for warranty service. You may contact the retailer or local TP-Link support.

▶ CES 2026 Meet TP-Link AI Assistant and More New Products!

Bell not powering on after battery recharge

Bell not powering on after battery recharge

Information

Voters 0

Tags