Early Access Tapo Smart Bulb Reset Method Update -- Reducing Bulb Resets Due to Unstable Power Supply
This Article Applies To
Tapo L510E(EU) 2.0
Tapo L510 V3.0
Tapo L520 V2.0
Tapo L530 V3.0
Tapo L610 V1.0
Tapo L630 V1.0
Description
In the future release, the Tapo smart bulb is planning to update its reset mechanism, removing the 3 times off&on method. Once the update is implemented, resetting the Tapo smart bulb requires an operation of 5 times off&on switches:
1. Turn the smart bulb to the On state.
2. Turn it off, then on.
3. Repeat five times, with 1-second pause in between (each off&on).
This modification will be helpful in situations where the smart bulb gets reset frequently due to an unstable power supply at home.
Pre-Release
Community users can receive early access to this new update. If you want to try out the new update, follow the steps below to apply the beta firmware.
How to Apply Beta Firmware
*Note: the pre-release is currently available only for the models mentioned under "This article applies to."
1. Find the Mac address of your Tapo smart bulb: Open the Tapo app and navigate to the smart bulb's Device Settings page > Device Info.
2. Send a private message to @Wayne-TP with this format: [Tapo Bulb Reset Method Update] + Mac address of your smart bulb
Before the Upgrade
(1) Please be sure you have read the Beta Test Agreement before upgrading the Pre-release firmware!
(2) How to update the firmware of the Tapo devices on the Tapo App
(3) Firmware downgrade is not supported. When a new official version is released, updating it will overwrite the beta version.
Feedback
We would love to hear your thoughts on the new firmware! Please feel free to share your experience in the comments. Your feedback will not only assist other users but also contribute to further improvements of the product.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Good afternoon @Wayne-TP , I have sent you 2 MAC Addresses, Thank you!
- Copy Link
- Report Inappropriate Content
Beta firmware has been sent to your devices, you may check it later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
@Skharel Beta firmware has been sent to your devices, you may check it later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
@chrisdmoon Beta firmware has been sent to your devices. You may check it later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
@rownie23 Beta firmware has been sent to your devices. You may check it later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Miro-slav Beta firmware has been sent to your devices. You may check it later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
Hi @Wayne-TP ,
Could I please get the beta firmware.
Kind regards,
JC
- Copy Link
- Report Inappropriate Content
@Wayne-TP I requested beta firmware for 2 of L530E devices. Thanks.
- Copy Link
- Report Inappropriate Content
Hello @Wayne-TP , I've sent you 6 mac addresses for my L630 light bulbs.
Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 8
Views: 4643
Replies: 62
Voters 6
