Home Network Community > Deco > Deco could'nt provide IPV6 to connected clients
< Deco

Deco could'nt provide IPV6 to connected clients

Deco could'nt provide IPV6 to connected clients

Deco could'nt provide IPV6 to connected clients
Deco could'nt provide IPV6 to connected clients
2 weeks ago
Tags: #IPv6
Model: Deco M4  
Hardware Version: V2
Firmware Version: 1.8.0

Today i was trying to setup IPV6 on my Deco M4 but my Deco got IPV6 address and DNS but could'nt provide IPV6 address and DNS to connected clients and even i tried every options which are available on Deco but nothing can work other than only option Bridge can work. My IPV6 settings provided by my ISP is showing in the screenshot below.

 

Please & Thank You !! ❤️
  0      
 
  0      
 
#1
Options
2 Reply
Re:Deco could'nt provide IPV6 to connected clients
2 weeks ago

  @ARGamingPK1 

Hi, thanks for the message.

I think you have reported it before on 1.7.0. Do you not want to use "Bridge Mode"?

https://community.tp-link.com/en/home/forum/topic/829120

 

Wait for your reply.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco BE85 1.2.0 Enhanced Mesh Backhaul Stability and Device Roaming Experience ▶Deco BE65/BE65 Pro 1.2.0 Enhanced Mesh Network Stability and System Security ▶Deco BE75 1.1.0 Added WireGuard VPN, Manual Channel Selection and More Try to leave a Message if urgent help is required.
  1  
  1  
#2
Options
Re:Deco could'nt provide IPV6 to connected clients
2 weeks ago

  @David-TP Yeah i don't want to use Bridge Mode and i want to use IPV6 as a Dynamic IP Address from Deco to connected clients.

Please & Thank You !! ❤️
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 94

Replies: 2

Tags

IPv6
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.