Solution What to do if Tapo P110 V1 1.3.4 requires reconfiguration frequently (LED blinking amber and green)?
This Article Applies To
Tapo P110 (AU/FR/UK/EU) V1.0 - Firmware 1.3.4 Build 250403 Rel.150504
Description
On a Tapo P110 V1 with firmware 1.3.4 Build 250403 Rel.150504, you may find the smart plug disconnects unexpectedly while the LED turns to blinking amber and green. And a reconfiguration is required to add the smart plug back to the app.
Solution
Relevant modifications will be added in the future firmware version.
Currently, a beta firmware is available for community users to address this issue. If you would like to try it out, follow the instructions below to apply the beta.
How to Apply Beta Firmware?
1. Check the Mac address of your Tapo smart plug.
2. Send a private message to @Wayne-TP with the following information:
[ID 840104][Tapo P110 V1 1.3.4 Auto Reset] + Mac address of your Tapo P110
Before the Upgrade:
(1) Please be sure you have read the Beta Test Agreement before upgrading the Pre-release firmware!
(2) How to update the firmware of the Tapo devices on the Tapo App
(3) Firmware downgrade is not supported. When a new official version is released, updating it will overwrite the beta version.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@GAUE I haven't received any messages from you. You may try to resend it. Log in first before sending the message.
- Copy Link
- Report Inappropriate Content
@andyk9 No message received yet. You can post them in the comment section. I'll notify you once the beta is sent, then you can re-edit the post to erase the Mac addresses, or simply delete the comment.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Wayne-TP have resent. Txs
- Copy Link
- Report Inappropriate Content
@GAUE Beta firmware has been sent to your devices, you may check it later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
widgeti wrote
@Wayne-TP I cannot update firmware because the device won't connect to my WiFi
@widgeti Check this article if you fail to set up a Tapo device. What should I do if I fail to configure the Tapo devices
- Copy Link
- Report Inappropriate Content
@Treaty_Toffee Beta firmware has been sent to your device. You may check it later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 1048
Replies: 28
Voters 1
