D235 skipping/jumping when connected to H200
My d235 is hard wired and set to always on mode. I have the storage set to the H200 Hub, however the footage skips and jumps a few seconds at the start of a new detection, almost like the pre record function isn't being captured correctly.
If I then try to watch it back in the timeline the same thing happens.
When I have the same configuration but the storage is set the the SD card inside the camera, all the issues are resolved.
I've tried formating the SD card, rebooting, checking for firmware update of the h200 and lots of other.
My hub is close to the router and camera so there shouldn't be any issues there either.
Any suggestions?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
What SD card to do you have what capacity.
I'll swap the doorbell storage back to my H200 Hub now just to test again
- Copy Link
- Report Inappropriate Content
@Tapoman69 that's my card
- Copy Link
- Report Inappropriate Content
@SugarBaby thanks
I've switched my storage back to the H200.
They may have fixed it for your specific camera but not the d235 doorbell.
Glad that it's sorted for you though😀
Let me know if anything changes and you get black lines or skipping again
- Copy Link
- Report Inappropriate Content
@Tapoman69 I will let you know hah ;d
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1001
Replies: 34
Voters 0
No one has voted for it yet.