Can not get my second H100 hub to finish and pair
I have factory reset this H100, and tried repeatedly to add to network. It goes through all of the steps except the last one of pairing. I have another H100 hub already working fine. I just can't add this second one.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Check this article for troubleshooting. What should I do if I fail to configure the Tapo devices
- Copy Link
- Report Inappropriate Content
@Augiek solved the problem by unplugging the first hub temporarily. Second hub went through the entire process smoothly. Original hub was interfering with setup.
- Copy Link
- Report Inappropriate Content
Check this article for troubleshooting. What should I do if I fail to configure the Tapo devices
- Copy Link
- Report Inappropriate Content
@Augiek solved the problem by unplugging the first hub temporarily. Second hub went through the entire process smoothly. Original hub was interfering with setup.
- Copy Link
- Report Inappropriate Content
Your case is quite unusual because an existing hub normally does not affect the configuration of another hub. Anyway, glad to know that your problem has been resolved!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 203
Replies: 3
Voters 0
No one has voted for it yet.