IP CAM NC200 // setup via tpcamera ok, wfi set-up ok, then dead ... .

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IP CAM NC200 // setup via tpcamera ok, wfi set-up ok, then dead ... .

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
IP CAM NC200 // setup via tpcamera ok, wfi set-up ok, then dead ... .
IP CAM NC200 // setup via tpcamera ok, wfi set-up ok, then dead ... .
2017-04-19 15:23:22
Model :

Hardware Version :

Firmware Version :

ISP :

Hi we have IP CAM NC200 latest FW

Set-up via tpcamera + test via local all works fine
Then in the last step it says: unplug cable to change to wifi
So we do so: then I see in settings WIFI Connection Status: connected
But cloud can not access the camera, ios app cannot connect
So in essence nothing works until I plug in the cable again

Is there some kind of Port Forward I have to enable? Something else?

Is there a difference between WIFI and UTP cable network?

Help appreciated

This is ERR log



















[2017-04-19/09:08:50]
Cloud
ERROR
Failed to send relayReady to cloud, result:-50010
[2017-04-19/09:03:42]
Cloud
ERROR
Failed to send relayReady to cloud, result:-50010
[2017-04-19/08:56:56]
Cloud
ERROR
NAT type:-1, errMsg:Success
  0      
  0      
#1
Options

Information

Helpful: 0

Views: 572

Replies: 0

Related Articles