Home

Forums

Stories

Knowledge Base

Smart Home Community > Tapo Smart Camera > NC450 initial position

< Tapo Smart Camera

NC450 initial position

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NC450 initial position

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

olesj

2017-08-22 18:38:54

Posts: 5

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2017-08-22

NC450 initial position

2017-08-22 18:38:54

Model : NC450

Hardware Version : NC450 2.0

Firmware Version : 1.2.4 Build 170322 Rel.85B2CB

ISP :

Hi

Is it possible to change the "initial position" button when using turn/tilt to stop on an nother position than the standart.

4 Reply

Anton L.Z.

LV5

2017-08-23 09:05:08

Posts: 1341

Helpful: 314

Solutions: 6

Stories: 0

Registered: 2016-04-19

Re:NC450 initial position

2017-08-23 09:05:08

you mean the reset button in the center? I don't see there is a way to change its position

olesj

LV1

2017-08-23 13:55:55

Posts: 5

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2017-08-22

Re:NC450 initial position

2017-08-23 13:55:55

Yes the reset button.

olesj

LV1

2017-08-23 14:31:18

Posts: 5

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2017-08-22

Re:NC450 initial position

2017-08-23 14:31:18

vieldcs

LV4

2017-08-23 16:45:09

Posts: 626

Helpful: 37

Solutions: 0

Stories: 0

Registered: 2017-06-28

Re:NC450 initial position

2017-08-23 16:45:09

I don't see a way to change it

NC450 initial position

NC450 initial position

Information

Voters 0

Tags