@TuL Hey I accomplished this by creating a Group and adding the gateway address into the group as shown below, as well as the ports for access I then created a switch ACL to stop the traffic from...

@userNAC Hey I have 3x EAPs and around 60 clients connected at most times, so far not used much over 2GB of space in a year on the USB drive so this should be fine for you

@Waycomb Directional antenna does have a slightly better strength over distances and through things when compared to an omni directional The bad thing about the onmi you have at the minute is that...

@Waycomb Hey ok, so you are looking at a signal strength of -70 to -80db which isn't great if honest. Usually in an installation, we could classify -70 as the limit, any lower it really classified as...

@BarryK As long as the EAP and controller can talk on the same LAN / VLAN then they don't specifically have to be on the same location/internet connection I have a number of sites that the controller...

You can try logging into the web interface of the switch and setting it for 1000mbps rather than auto This would basically force the connection online, see how that works for you. Ideally do the same...