@goryo Its been a while since I looked at a CPE, but I would recommend you try the following Enable MaxStream Change the bandwidth to 40mhz (anything but 10mhz)

@andywa206 If you are using Deco with an ISP router.. you will likely need to set up 2x forwarding rules to avoid the double NAT scenario 1. ISP Router to Deco Main eg.. port 80 to 192.168.68.1 2....

@QuakerWildcat Just thinking out loud here.. but there is an option comes to mind Take a note of your routers IP Address and Disable the DHCP on your current router. Lets say its IP is 192.168.1.1...

@drgonzoo Ah ok.. never tried this with an offsite AP, only ever been local / native

@Rob_CTL It shouldnt really if honest, however I have been known to over-ride (manually set) APs to specific channels on occasion. However, errors on 2.4 are nothing to be concerned about, this will...

@drgonzoo If memory serves me correctly, i was able to change the IP on the controller without hassle