@GRL I am seeing the same thing on my OC200 - "Unable to connect to the controller. Please check your network connection and ensure that the controller is running normally." Refreshing usually clears...

@MR.S How do you do this through the Omada controller? You can't access the CLI once it's managed by the controller.

How does one go about creating a blanket deny all incoming traffic on the WAN ports from the Internet? The ACL section of the latest controller code doesn't allow port selections, only...

@RickRick123 Wish I had that option, my EAP610's are outdoor units, acting as mesh root's for distant networks, so I have no choice but to 'deal' with it, or use an EAP225 with reduced performance....

@papac0rn I've tested 1.3.0, 1.3.1, 1.4.0, 1.4.1 and now 1.4.93 and they all have the reboot issue (some worse than others). I've had 3 reboots on 1.4.93 in less than 24 hours. I've sent logs and...

@papac0rn They sent me the new firmware and it hasn't resolved the issue unfortuately. I have 2 separate ethernet connected EAP610's that act as mesh roots. The mesh connection between one of the...