Oliv2831LV2Online
Following: 0Followers: 0
Forums/ Controllers
Tuesday
Re:Showing radio settings in Device view
@Vincent-TP Now I see this menu. I'm not very proud of myself as I specifically looked for it. This is exactly what I was after. Thank you very much for helping
0HELPFULS
Forums/ Controllers
Tuesday
Re:Showing radio settings in Device view
@Vincent-TP The first check I'm looking after, is about Channel frequency and bandwidth, TX power, in each radio band. Adding channel utilization to these values would be helpful though I'm yet...
0HELPFULS
Forums/ Controllers
a week ago
Showing radio settings in Device view
Hello, I often install AP in corridors and give each a sequential name like AP01, AP02, AP03. When looking a Device View, I can see the following columns: Name, IP address Status Model Version...
0HELPFULS
Forums/ Wireless
a week ago
Re:EAP6110 went crazy, 50% network load, without any client
@Vincent-TP Maybe, a diagram separating RX, TX and Interferences would help people from mis-interpreting displayed figures. In my case, I'll change radio settings in 2.4 GHz band (selecting different...
0HELPFULS
Forums/ Wireless
a week ago
Re:AP has a 60% Rx rate in 2.4 GHz band while no connected client in the same band
@Vincent-TP Thanks for replying. My case share seems similar with the one referenced above. I'll post my replies there to make them more useful.
0HELPFULS
Forums/ Wireless
a week ago
AP has a 60% Rx rate in 2.4 GHz band while no connected client in the same band
Hello, In a building in which 50 APs are installed, I looked at an AP stats (EAP653 with 11.3 firmware). I'm seeing that this AP : has a low usage (3% in RX, 1% in TX) in 5 GHz band has a high RX...
0HELPFULS
123...