WiFiGuy01 wrote @UKJim ...and especially one outdoors at an event where the noise floor will be impacted by thousands of mobile phones. Every single one of your AP's should be backhauled to one or...

@WiFiGuy01 OK, understood. So ideally I should cable for wired backhaul from the switch located at each mesh to each AP? I take it you have practical experience of Omada in this respect? Do you work...

WiFiGuy01 wrote I'm slightly confused. What are your reasons for wantiing to use individual PSK's for every stand if you're just going to have them all on the same VLAN? Thinking this setup will work...

@Hank21 Hank21 wrote @UKJim One SSID can have up to 128 passphrases. This is a performance restriction of the OC200. If you create two SSIDs, you can specify two profiles with the same VLAN ID. The...

Hi Support, We are building a wifi mesh for a large village showground in the UK (Heckington Show, Heckington, Lincolnshire). OC200 controller, router ER706W-4G, bridge tx/rx 2 x CPE710, switches 2 x...

@d0ugmac1 No, removing poe from one child results in its status being Disconnected (the root AP stays connected). Also when you reconnect poe to the child I earlier said it re-Adopts, but I should...