Today I did a full factory reset on all the gear. In reconfiguring my network I discovered what I think is the problem. I've discovered a routing behavior that did not exist in the 2.2.6 firmware for...

@GRL In the screen shot, you can see all the ports (blue highlight) are trunked and the (red highlight) are the ports for the devices that are in the vlan.

@GRL @Gabriel-TP Thanks for the reply. The versions are below. The problem isn't with the EAP, that only provides DHCP to the default(1) lan which is still working. The problem is with a wired only...

After performing firmware updates on for the Omada Controller (OC200), router, and switches, I started having problems with my VLAN behavior. I deleted everything and created a new VLAN. Wired...

@Clive_A Again thanks for the reply. I mentioned the VPN because it is part of the overall config of the router and to illustrate what parts of the vlan setup was working. The devices that I am using...

To follow up on my previous posts. I deleted the Lab vlan. Disconnected the lab devices. Rebooted router and switch. Readded the lab vlan, setup the permit acl, reconnected the devices. Still unable...