@MR.S You can change it in your account settings.

Hi, I would like to know if NAT loopback was removed in version 1.3.1 because I can't connect via URL on my servers after updating. Here's how my network is setup : ISP's -> ER8411 -> SG3428X ->...

@Vincent-TP @Hagi79 I can see it in the WAN settings under 'Advanced DHCP Options' after updating my ER8411 to 1.3.1.

@CostinR1 You can disable the WAN Settings Overrides if you go the Controller route. That means that the configuration in standalone mode will transfer when adopted. I can confirm that when the...

@Hagi79 You need the adapted gateway firmware.

@Clive_A Thanks for the quick reply. I did a factory reset, updated in standalone mode and then adopted it and its working again. I don't know what happened.. As for the ACL rule it was a GW rule to...