@Maruho Hi, After you download firmware 1.5.0 on the computer, you could disconnect the hotspot now, and connect to MR600 since the local firmware upgrade does not require internet service.

@Federica Hi, the beta firmware is on the first page, and please try to install the pre-release 1.5.0 firmware.

@MarcioS Hi, Normally, the Ethernet backhaul does not need additional configuration and it should be active once the cable is plugged in. But we do get some feedback that some switches do not support...

Stylax wrote Hi, Can someone please help me out on three points relating to setting up a Deco Mesh system over Wifi. I have had a response from tech Support which says attach my Deco unit to a modem...

@cmonbux Hi, I have sent the email and quoted the last email content. Could you please check again whether you could get any email from TP-Link? Thank you very much.

@McClean7 Hi, thank you very much for your time and patience. Did the same issue start again after posting this thread? If yes, could you please help me check the following information: 1. Would all...