@MarcotteMW, CPE510 cannot be linked with CPE210. The former is a device operating in the 5 GHz band only, while the latter is a 2.4 GHz device. What you can do is to link two CPE210 or two CPE510,...

@BruMa, first of all, OC200 always sends untagged traffic. If you want to use wireless networks in different subnets, you need to use Multi-SSIDs assigned to the corresponding VLAN. Why? Because you...

Byteguy wrote But as I said, once I set up the Controller, it finds no EAP. There is definitely a routing problem. If I set up a directional link between CPEs and connect an EAP to the remote CPE, it...

@hashrack, again: take a look at the SNR of clients which are at the edge of the covered area. They can cause massive re-trasmissions. Next, change the WiFi channel (and channel bandwidth if it is...

@Questionmark, that's a good point, too! That's why I recommend to set the WiFi mode to 802.11n-only for the 2.4 GHz radio and n/ac mixed for the 5 GHz radio (if not needed for compatibility with old...

@scat, I suggest to check with another cable and if this does not help, with another port of your switch.