@fhew You mentioned discovery was broken, are you saying you can't make direct UDP control calls to the devices either? That would be more concerning - there are a few network problems that can break...

@fhew If udp is broken and you're using an aftermarket app you'll need to assign them reserved IPs in your router and use that apps "discovery by IP" function (assuming it has it).

@DaddyVader58 Try rebooting your router next time it happens - this is often caused by the router after running for a while. You might double check that the bulbs really are disconnected from wifi by...

@ThisGeekRyan Sounds like you didn't keep all of the black line wires together, only the black load wire to the light should be separate on the switch. The other blacks go on to send power to the...

@bachastain I don't have a KL130 to verify, but I do have an LB130 and it's not using multiple IP addresses. Those MACs are competely different, usually they'll be close or even sequential when...

@Cflook00 Well, they're not electricians, they're tech support... but I think what they're trying to say is 2 gang light switches - two switches in one physical device - are not supported. But two...