@Haval Hi, USSD function is working on 3G/2G network only, so it is normal that the router falls back to 3G when you use USSD function. Normally when you stop using the USSD function, it will switch...

@Juulis Hi, based on the screenshot, only band 38 is selected manually, please note that the band selection is for 4G network instead of 3G. Network mode is set to 4G Preferred, which means it will...

@iloveu @MobileRouter @kernash Hi, we've confirmed with senior engineer that the old firmware had an issue about the 4G+, old firmware might display 4G+ when it actually works on 4G in some cases,...

@lisander_8s Hi, 802.1Q usually means the VLAN Tagging, and it should be enough to configure VLAN ID. In addition, are you using Static IP as the WAN connection type? If it still doesn't connect to...

@KennethS Hi, when checking the system logs, you could save the log file, even though there are many logs about the IGMP Warnings, you are still able to check all the other logs to monitor the...

@vinou770 Hi, you could use all the four powerline units at the same time within the same powerline network: Connect one TL-PA7017 to your router via Ethernet cable, all the three units can be...