@Lorena0505 Hi, Deco M5 have repleased new firmware and now supports connection preference and IOT network. But it does not support device isolation at present. You can check the supported models...

@Kowax Hi, So is it working normally before, and the issue comes out after you set up the guest network? Please try to disable QoS and then enable it again. If it still cannot work, please also offer...

@AurelienM Hi, Deco X50 supports NAT loopback, but it only supports the TCP protocol.

@MonkeyOnKeyB Hi, This model VX800v does not supports Access Point mode. Besides, it is a ISP customized model. If you would like to buy a DSL modem router from online or local store by yourself, it...

@Cyjam Hi, May I know the hardware and firmware version of your TL-WPA7617 KIT? It should support OneMesh. You can refer to this guiance to set up OneMesh with the router first. How to...

@Soer Hi, What is your device model? Are you using OneMesh or EasyMesh? You can first refer to the guidance below to set up Mesh system. For EasyMesh: How to add your TP-Link PLC to an EasyMesh...