Today I had issues mostly about websites not loading, while speedtest worked. And some other sites loaded, too. I ruled all LAN to WAN1 port to avoid traffic to go to the WAN2 that is a 4G modem. And...

First I had issue with my router (Archer C6 v2), in access point mode, showing orange led and partly loosing internet. It is connected to an easy smart switch that is connected to the R605. So I went...

I created the ACL rules in Firewall. It seems to work, however I need some clarification: - Source network and destination network. It seems obvious, right? But when I wanted, let's say, to block...

@Fae Thanks again. I see intervlan is a valuable feature on the router, I was just wondering why there isn't an easy (one tick) option to block it when people don't need it. But of course, I can use...

@Fae Thank you for that tip about enabling the layer-3 accessibility in EAP. I still don't really understand the intervlan concept. If I configure each LAN port of the R605 with different VLAN, PVID...

This beta firmware (1.1.0 Build 20210531 Rel.59047) solved the inter-vlan problem, mostly. Setting up vlans with different IP subnet is quite easy. (However, it's not in Transmission -> NAT section...