@Athakr Hi, thank you very much for the feedback. Did this Deco work properly when set up separately as the main Deco? It is also suggested to refer to this link to run a firmware recovery on this...

@Spalacios Hi, you can connect one of the old E4 via an Ethernet cable to one of the new Decos, then set a new Mesh network with the old Deco E4. Or you can refer to this link to run a firmware...

@gonzague31 Hi, welcome to the community. Is the IPV4 address on the Deco App>More>Internet Connection the same as the displayed IP address on https://whatismyipaddress.com/ Wait for your reply. Best...

@pjs_gsy Hi, nice to see you again. It is planned to add Channel/Channel Bandwidth Selection on different models, but it is unclear when the firmware will be released for a certain model. If you're...

@lapsmith Hi, you can install the firmware here, which has added Connection Preference: Deco S4_1.7.0_build_20250926_Beta Wait for your reply. Best regards.

@tomkao Hi, did you set NextDNS in both the primary and secondary DNS servers under IPV4, such as: Primary: 45.90.28.232 Secondary: 45.90.30.232 Wait for your reply. Best regards.