@Seadon Hi, welcome to the community. Please refer to this link to help me submit the Deco App log:How to submit Deco APP log Then, it is suggested to install the 1.2.0 firmware here to see whether...

@63Vino Hi, thank you for the update. When "Smart DHCP" is enabled, even in AP mode, Deco could assign IP addresses for mobile devices to maintain an active local connection if the actual DHCP server...

@ARGamingPK1 Hi, I think it might still be related to App UI adaptation, which needs further optimization. "Other" category on Deco M4 only refers to "IoT Network". (I don't have Deco M4 on the Deco...

@tatsa Hi, nice to see you again. The "Connection Preference" feature should always be available under "IoT network". While there was occasional feedback that smart home devices didn't always connect...

@Nardol Hi, nice to see you again. The official 1.8.5 version is the same as the last beta.bin version. Best regards.

@Nardol Hi, Non-address mode for IPv6 is often used when the ISP will not provide the full IPv6 address to the router's WAN, only the Prefix Delegation. So under Deco APP>Internet Connection>IPV6,...