@MrParticular I only want WAN 2 for failover and that is how it was set up. So when I run a speedtest and I'm on WAN 1, the reported speed would roughly be the speed, no? I'm not trying to split...

@Daniel_NL Sorry for the late response. I tend to set the OC200 back to factory default once again. And restore my back-up file. Then everything works ok (untill next reboot). Maybe you can check the...

@MrParticular As you may know, Load Balance selects which WAN port is session-based. When there are a lot of sessions established with end-points, the Load Balance router can assign these connections...

Dear @Ciploker, Thank you for posting the problem on the TP-Link Community. The traffic doesn't want to be routed as set in static route nor policy routing for some cases. We haven't received such...

Dear @Nek, how can i isolate so that ports from one room dont "see" ports of other rooms. Port 1 is our uplink. Thanks The 802.1Q VLAN may help. Devices from different VLANs cannot achieve Layer 2...

@vailski04 I'm told it should automatically restart, which it is not doing. Any suggestions around why the router would not allow me to activate port 2 as WAN? I've tried both with the bridge...