I am trying to set up a newly purchased gateway (ER7412-M2) but I cannot access or “find” it. An on-site technician connected it to a switch, and I can see that the switch port is up. I can also see t

I'm trying to configure an ER7212PC controller with a bunch of AC1350 access points so that I can have multiple SSIDs - both have internet access, one will also connect to the wired networks, but the

I manage two sites with my OC200 v1.0 controller. The gateway of the secondary site reports over internet into the controller which is located in my primary site. Setup of primary site: 1 x OC200 v1.0

I'm looking for a solution to reach a VPN client from another VPN client, using the ER7412-M2. The situation: I have professional cameras with remote control option. The control SW works on iPad only.

How can a client connect to the system without being assigned an IP address? How does data transfer work in this case?

Tried to set up 8x EAP653's with my OC200 today, ran into issues because they either did not adopt, or if they did adopt would soon disconnect. Worked out the issue was them falling back to their defa