Hi, after upgrading to latest firmware 1.0.12 build20230829, parental control is stopped working. Could you please suggest the solution?

I have an EasyMesh setup with Archer C64 as the controller and 2 satellite devices using wireless backhaul. I want to check the signal strength of the satellite devices but there is no indicator apart

I have an AX6000 router after a storm. I have access to the router console. It's in bootloop. I can abort boot and get into recovery mode. Then I have access via www and I can upload the firmware. Aft

I have recently purchased the TP-LINK Archer AX53 AX3000 Wi-Fi 6 Gigabit Router from Amazon. I was using Archer C80 before this one. I am noticing that navigating through the Web GUI and the Tether ap

This is for the AX80 model with the internal antennas. https://www.tp-link.com/au/home-networking/wifi-router/archer-ax80/ I can't get this router to maintain throughput on 5Ghz 802.11ax 80MHz channel

last month i noticed that router from some reason reset itself to default settings and i need to upload the saved configuration file to the router to make it work again it's very annoying issue and i'